How to Charge a Power Station With Solar Panels
Five steps from unfolding a panel to a full battery.
To charge a power station with solar, connect panels whose voltage stays within the station's solar input range using the right adapter, aim them straight at the sun, and expect roughly 300 to 450Wh per 100 watts of panels on a clear day.
Steps
- Check limits. Find your station's solar input watts and voltage range in its manual.
- Get the right cable. Most panels end in MC4 connectors; stations usually take XT60, Anderson or a brand-specific plug. Brand panels usually come with the right cable.
- Wire panels. Series adds voltage, parallel adds current. Stay under the station's maximum voltage.
- Aim them. Face them south in the U.S., tilted roughly to your latitude. Re-aim every couple of hours for the most output. Avoid any shade; even part of one cell shaded cuts output a lot.
- Watch the input. The station's screen shows solar watts coming in. Compare it with your panel rating to see how you're doing.
How long it takes
Divide the station's capacity by the actual solar watts. A 1,024Wh station getting 300 watts takes about 3.5 hours of strong sun.
Tips
- Keep the station in the shade with its vents clear; heat slows charging.
- Many stations can charge from solar and wall at once for faster refills.
- LiFePO4 stations won't charge below freezing; see cold weather.
Questions
Can I charge a power station while using it?
Yes, all of these support pass-through, so solar can run your loads and charge the battery together.
Do I need a charge controller?
No. Power stations have a built-in MPPT charge controller.